3. Factory Setting. 4. Master -Slave Control

3. Factory Setting

With A001~A512 any address code, press 3 seconds through key Ў°MEMUЎ± to enter the Ў° factory SettingЎ±, Factory Settings mainly include lamp output power, fan setting mode, setting temperature protection point and sending parameters. In Factory Setting any mode,, press 3 seconds through key Ў°MEMUЎ± to exit.

R255	R032	Modify the Red bead current by the key Ў°UPЎ± or Ў°DOWNЎ±(R032-R255), save by the keyЎ±ENTERЎ±, defaul R220.
G255	G032	Modify the Green bead current by the key Ў°UPЎ± or Ў°DOWNЎ±(G032-G255), save by the keyЎ±ENTERЎ±, defaul G220.
B255	B032	Modify the Blue bead current by the key Ў°UPЎ± or Ў°DOWNЎ±(B032-B255), save by the keyЎ±ENTERЎ±, defaul B220.
FAN0	FAN1	Fan Settings: Start the fan when the FAN0 lamp is on, Start the fan when the FAN1 temperature reaches 40Ўж, save by the keyЎ±ENTERЎ±.
T040	T070	Set the temperature protection point. Modify Parameters by the key Ў°UPЎ± or Ў°DOWNЎ±ЈЁ40Ўж~70ЎжЈ©Јsave by the keyЎ±ENTERЎ±, defaul T060.
Send	Send	Send machine factory Settings parameters by the key Ў°UPЎ± or Ў°DOWNЎ±, to all other lamps connected in parallel with 3 core signal wires; Confirm sending parameters and press the key Ў°menuЎ± for 3 seconds to exit, Deny sending parameter press the key Ў°ENTERЎ± to undo.

4. Master -Slave Control

Two or more of the same lamps are connected with DMX 3 core signal wires, set all lamps to any address code from A001 to A512Јset any one as the master and the other lamps as the slave, all the slave screens do not blink; When the master machine is used to adjust the sound control and self-moving effect, all slave machines synchronize the sound control and self-moving effect.

Special Remarks: 1. Only one master can be set for a group of lamps. If there are more than one master, all lamps will flash randomly and not synchronize.

2. All lamps must be active when the DMX512 console is turned off.

⇐ Предыдущая 1 2 345 Следующая ⇒